Front End Suspension Master Rebuild Kit Idler Arm Compatible with Plymouth Barracuda with Disc Brakes OEM Spec Replacements (27 Piece Kit)

This Kit is constructed using High-Quality OEM spec replacements for 1964, 1965, and 1966 Plymouth Barracudas with Factory Disc Brake Lower Ball Joints. **Aftermarket Disc Brake Conversion Kits will Not Fit.** These parts are Factory Design and will only work with Stock Vehicles. This Kit Contains All Of The Pieces Below: Inner Tie Rod Ends (Right and Left), Outer Tie Rod Ends (Right and Left), Tie Rod Sleeves (2 Each), Upper Ball Joints (2 Each), Sway Bar Links (2 Each), Strut Rod Bushings (4 Each), Lower Ball Joints (2 Each), Upper Control Arm Bushings (4 Each), Lower Control Arm Bushings (2 Each), Upper Control Arm Bumpers (2 Each), Lower Control Arm Bumpers (2 Each), and Idler Arm. This Kit Also Contains The Cotter Pins, Rubber Grease Seals/boots, Zirc Fittings (When Applicable), And The Bolts For The Ball Joints, Plus The Tie Rod Sleeve Bolts, Nuts, And Clamps.

• YEARS: 1964, 1965, and 1966
• MODELS: Compatible with Plymouth Barracudas with Disc Brakes
• HIGH-QUALITY: OEM Spec Replacements
• INCLUDED IN THIS 27 PIECE KIT: Inner Tie Rods (2 Each), Outer Tie Rods (2 Each), Tie Rod Sleeves (2 Each), Sway Bar Links (2 Each), Strut Rod Bushings (4 Each), Upper Control Arm Bushings (4 Each), Lower Control Arm Bushings (2 Each), Upper Ball Joints (2 Each), Lower Ball Joints (2 Each), Upper Control Arm Bumpers (2 Each), Lower Control Arm Bumpers (2 Each), Idler Arm
• ALSO CONTAINS: the cotter pins, rubber grease seals/boots, zirc fittings (when applicable), and the bolts for the ball joints, plus the tie rod sleeve bolts, nuts, and clamps.
• ***Vehicles with Aftermarket Disc Brake Conversion Kits will Not Fit. These Lower Ball Joints are the Factory Stock Disc Brake Design with the 3.850" (center to center) Spacing on the Mounting Holes. If your Spacing is 4.375", then you will need the later design. Please contact us and we can swap these for the Factory Design.***